Skip to main content
Tall Ship Productions

Children's Museum Tucson

Tabletop Color Shadow Lamp

Tall Ship Productions, LLC designed, fabricated, and installed a fixed tabletop lamp for the color shadow table in Children's Museum Tucson's Playing with Light gallery. An existing table was used to reduce the cost of the display fabrication.

Black pipe lamp mounted to a round table, casting overlapping colored shadows in a darkened gallery.

The Challenge

The color shadow lamp complements the other displays in the Playing with Light exhibit, giving young explorers a hands-on spot to cast cyan, magenta, and yellow shadows from the red, green, and blue LEDs inside the lamp. Where the Color Shadow Theatre fills a wall with light, the tabletop lamp brings the same color mixing down to a child's eye level, where blocks, shapes, and hands become the shadow makers.

The design had to do three things. It had to hold the light in one fixed position, centered over the table and aimed straight down, so the shadows land where the exhibit intends. It had to be sturdy enough for active hands from age two up in a darkened gallery. And it had to put a barrier between small fingers and a bulb whose entire body is a heat sink, without blocking any of the light that makes the exhibit work.

The Process

  1. Step 1Built a fixed black-pipe portal frame: two posts into floor flanges through-bolted through the tabletop onto steel backing bars, a beam across the top, and the lamp hanging from a tee at mid-span allowing the three LED light sources to cast an even light across the table.
  2. Step 2Designed and 3D printed a bulb guard in ASA from a 3D scan of the actual bulb and socket, so the clearances came from the real parts rather than a catalog drawing. The guard's profile echoes the flare of the lamp itself, and its hexagonal vents are sized smaller than a toddler's fingertip while leaving the heat sink room to breathe. The bulb emits only from its flat lower face, so enclosing the sides costs nothing optically.
  3. Step 3Ran all of the wiring inside the pipe frame itself, so every electrical component sits safely away from visitors' hands.

The Result

The lamp is now part of the table rather than an accessory to it. The light sits in one place, centered, at a height chosen for the shadows rather than for brightness, and the three LEDs spread an even field of color across the whole tabletop. Young explorers find the shadows ready to play with on every visit.

Every dimension came off the real hardware. The project went through several rounds of dry fitting and measurement before installation, and the museum receives full assembly documentation so the fixture can be serviced, re-lamped, or rebuilt without guesswork.

Image Gallery